Tankless Water Heater Savings Calculator: Estimated Annual Savings

Switching from a storage tank to a tankless water heater saves energy because the tankless unit does not keep a tank of water hot. This tankless water heater savings calculator estimates the saving from your current annual water-heating fuel cost and the efficiencies of the old and new units. Department of Energy’s Building America field test.

Heating & Cooling Cost Calculators

Tankless Water Heater Savings Calculator

Estimated annual energy-cost savings from switching a storage tank water heater to a tankless unit, from fuel usage and efficiencies.

$
%
%

The starting values are a $400 annual cost, a 60% storage tank and an 85% tankless unit. That gives a new cost of $282.35 and savings of $117.65 a year.

How are tankless water heater savings calculated?

Fuel use is inversely proportional to efficiency, so the new cost is the old cost times the old efficiency divided by the new efficiency.

New cost = Current cost × (Tank efficiency ÷ Tankless efficiency)
Savings = Current cost − New cost

Where current cost is your annual spend on fuel for water heating, tank efficiency is the rating of the storage heater, and tankless efficiency is the rating of the new unit. Both efficiencies are entered as percentages.

Worked example: the starting values

New cost = 400 × (60 ÷ 85) = $282.35
Savings = 400 − 282.35 = $117.65

That is 117.65 ÷ 400, or 29.41% less fuel cost, assuming the same fuel price and the same hot water use.

How does it compare with the Department of Energy’s figures?

A 2013 Building America report for the Department of Energy says tankless gas water heaters should save approximately 33% on hot water heating. It compares a typical tankless energy factor of 0.8 with 0.6 for a storage unit, and its field test used a 0.82 tankless unit and a 0.60 storage unit in an occupied two-person home.

The 33% figure is the rise in efficiency, since 0.8 ÷ 0.6 is 1.33. The fuel saved is smaller, because fuel use falls by 1 − 0.6 ÷ 0.8 = 25%. The calculator uses that fuel-based arithmetic. At 60% and 80% it gives $300.00 from a $400 bill, a saving of $100.00 or 25%. At 60% and 82% it gives $292.68 and a saving of $107.32, or 26.83%.

Efficiency pair New cost on $400 Savings Share saved
60% and 80% $300.00 $100.00 25%
60% and 82% $292.68 $107.32 26.83%
60% and 85% (default) $282.35 $117.65 29.41%

Energy factor versus UEF

The report uses energy factor, not the Uniform Energy Factor shown on the calculator’s input labels, and it does not mention UEF at all. Use the efficiency rating printed on each unit’s label for whichever rating you have, and do not mix the two.

Why real savings can be lower

The report says savings are smaller at low hot water draws and approach the rated 80% efficiency at draws of 10 gallons or more, with the greatest savings at about 50 gallons of hot water a day. The calculator applies one flat ratio, so it cannot show that pattern. A small household that uses little hot water could save less than the result.

Worked examples for different homes

Worked examples

Larger bill

With a $600 bill at 60% and 80%, the new cost is $450 and the saving is $150 a year.

Matching the field test

Enter $400, 60% and 82%. The saving is $107.32 a year, or 26.83%.

No efficiency gain

If both units are rated 60%, the new cost equals the old cost and savings are $0.

What the calculator leaves out

It does not include the price of the unit, installation, venting, gas line or electrical upgrades, or any difference in fuel type or price. It is an energy-cost estimate only, so divide your installed cost difference by the yearly saving to judge payback.

Frequently asked questions

How much can a tankless water heater save?

The Department of Energy’s Building America report says approximately 33% on hot water heating. Fuel use falls 25% when efficiency rises from 0.6 to 0.8.

How do I calculate tankless water heater savings?

Multiply your current cost by tank efficiency over tankless efficiency, and subtract it from your current cost.

What are typical efficiencies?

The report uses 0.6 for a storage unit and 0.8 for a tankless unit, and tested 0.82 and 0.60.

Why is the default saving 29.41%?

Because 60 ÷ 85 is 0.706, so the new cost is 70.6% of the old cost.

Does the calculator include the cost of the heater?

No. Add the installed price separately to work out payback.

Do I save less if I use little hot water?

Yes. The report says savings are smaller at low draws and peak at about 50 gallons a day.

Mark Danny

Mark Danny

Mark Danny builds and maintains the free calculators and guides on Area of Irregular Shapes Calculator. Every calculator page explains its formula and shows a worked example, so you can check the working yourself. Spotted a mistake or have a suggestion? Email gulsher.hingoro101@gmail.com.

Articles: 559