Heater wattage depends on the size of the tank and on how far the water must be warmed above room temperature. This aquarium heater size calculator takes your tank volume in gallons and how much you need to warm the water above room temperature, then returns the heater wattage using a watts-per-gallon rate.
Aquarium Heater Size Calculator
Recommended aquarium heater wattage from tank volume and how far above room temperature the tank needs to be.
The starting values are a 55 gallon tank with a moderate temperature rise, which gives 220 watts.
How many watts does an aquarium heater need?
Multiply the tank volume by a watts-per-gallon rate that depends on how far you need to raise the temperature.
Watts = Gallons × Watts per gallon
Where gallons is the tank volume and the rate is chosen by temperature rise: 2.5 watts per gallon for a small rise of 5°F or less, 4 for a moderate rise of 5 to 10°F, and 5.5 for a large rise of more than 10°F.
Worked example: the starting values
Watts = 55 × 4 = 220 W
A small rise gives 55 × 2.5 = 137.5 W and a large rise gives 55 × 5.5 = 302.5 W for the same tank. The 55 gallon tank is about 208 liters.
Worked examples for different tanks
Worked examples
Small tank in a warm room
Enter 20 gallons with a small rise. The result is 20 × 2.5 = 50 watts.
Large tank in a cold room
Enter 75 gallons with a large rise. The result is 75 × 5.5 = 412.5 watts. Split that across two heaters of about 220 watts each.
What the calculator leaves out
It does not account for tank material, lid, room drafts, flow or target temperature beyond the three rise bands. Choose the next heater size up from the result, set the thermostat to your target, and watch the thermometer for a few days.
How tank size and temperature rise change the heater size
The table shows four tanks at each of the calculator’s three rates.
| Tank | Small rise (2.5 W/gal) | Moderate rise (4 W/gal) | Large rise (5.5 W/gal) |
|---|---|---|---|
| 20 gal | 50 W | 80 W | 110 W |
| 40 gal | 100 W | 160 W | 220 W |
| 55 gal | 137.5 W | 220 W | 302.5 W |
| 75 gal | 187.5 W | 300 W | 412.5 W |
Working out the temperature rise
The rise is the target temperature minus the temperature of the room the tank sits in. A tank that holds 78°F in a room at 70°F has a rise of 8°F, which is in the moderate band, and one that holds 78°F in a room at 62°F has a rise of 16°F, which is in the large band. Use the coldest room temperature you expect.
Using more than one heater
For a large tank it is common to split the wattage across two heaters, one at each end. For 75 gallons with a large rise, the result of 412.5 watts can be met by two heaters of about 200 to 220 watts each. If one fails, the other keeps the tank from cooling quickly, and the load is spread along the tank.
Setting up the heater
Set the thermostat to your target and check it against a separate thermometer, because the dial on a heater is not always accurate. Leave the heater time to settle before you add livestock, and keep a spare in case of failure.
Frequently asked questions
What size heater for a 55 gallon tank?
At the calculator’s moderate rate it is 220 watts. A range of 3 to 5 watts per gallon gives 165 to 275 watts.
Why is the small-rise rate below the published range?
The calculator uses 2.5 for a rise of 5°F or less, which is under the common minimum of 3. Treat it as a floor and round up.
How do I find the temperature rise for my tank?
Subtract the room temperature from the target water temperature. A tank held at 78°F in a 62°F room has a 16°F rise.
Should I use one heater or two?
For a large tank two smaller heaters spread the heat and give a back-up if one fails. For 75 gallons, two heaters of 200 to 220 watts are close to the 412.5 W result.
What size heater for a 20 gallon tank?
With a small rise the calculator gives 50 W, and with a moderate rise 80 W. Round up to the next size available.
